Forum registration by users has been re-enabled with harder registration questions. Guests should use the Register button top right but if you have difficulty answering one of the spambot countermeasure questions, Email mail @ chalkevalley.info (delete spaces).
If you would like to join the DLOC, please visit the Club's website https://www.dloc.org.uk/
Please don't post someone's email address. Some people don't want to risk it being harvested by spambots and GDPR regulations discourage it.
Always look at "ACTIVE TOPICS" which gives all posts in date & time order if you can't find a post or "Your Posts", as topics are sometimes moved.
Reg. nrs. Please add reg. nr. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.

Various Daimler V8 250 Engine Parts

Post Reply
Willsparker
Posts: 9
Joined: Wed Feb 15, 2017 7:26 pm
Location: West Berkshire

Various Daimler V8 250 Engine Parts

Post by Willsparker » Fri Sep 20, 2019 9:33 am

Hi,

A few years ago, I bought a '67 Daimler V8 250 with the intention of restoring it, and in the process bought an additional V8 engine (along with the one in the engine bay). A few years down the line and I've decided to change my mind on restoring it, and want to go in another direction, so I have the following bits up for sale:
- A short engine (block, pistons, crank, sump etc. Still turns, and the cylinders don't look in too bad condition, however the area where the heads go could do with a skim)
- An auto-gearbox (not sure of inside condition, but the casing has some light ali corrosion. Can turn the prop shaft end)
- A bare engine block (No cracks, but surface rust on most areas. Would be a good candidate for boring out to a bigger capacity)
- 2 Pairs of cylinder heads (one pair stripped of valves and springs, one pair intact. Both will need skimming, though one pair isn't as bad as the other)
- 8 rocker arms (4 ingood condition, 4 are corroded)
- 2 sets of both long and short push rods ( for 4 heads )
- 2 sets of Head Bolts ( for 4 heads )
- Aluminium sump
- A single pair of Carbs
- 2 water pumps
- an intake
- air filter box and supporting bracket/tubes.
- distributor (Will need refurb)
- Dynamo (unknown if working)
- Starter Motor (unknown if working)

Those are the main bits, but I'm essentially selling 1 complete and 1 nearly complete engine, so either private message or email me if there's anything else I may have.
Cheers,
Will

Post Reply