Forum registration by users has been disabled because of many problem registrations from Russia. Email mail @ chalkevalley.info (no spaces) if you wish to join the forum and an administrator will register you.
If you would like to join the DLOC, please visit the Club's website https://www.dloc.org.uk/
Please don't post someone's email address. Some people don't want to risk it being harvested by spambots and GDPR regulations discourage it.
Always look at "ACTIVE TOPICS" which gives all posts in date & time order if you can't find a post or "Your Posts", as topics are sometimes moved.
Reg. nrs. Please add reg. nr. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.

heater control panel

Post Reply
keithj
Posts: 25
Joined: Sun Nov 25, 2018 10:29 pm
Location: Mansfield

heater control panel

Post by keithj » Sat Feb 09, 2019 12:01 pm

My project has moved from electrics (successfully completed) to heater. The problem is quite simple the control lever is floppy while at the valve end the cable is attached OK. I need to get to the lever end of the cable and the manual helpfully tells me how to do it. Remove chrome screws, easy, then withdraw the wooden fillet below the instrument panel. Anyone any advice on how to manage this tactical withdrawal? I don't want to use too much force as the veneer is still good around here.

johnwager
Posts: 51
Joined: Thu Feb 11, 2016 3:26 pm
Location: Thundersley, Essex

Re: heater control panel

Post by johnwager » Sat Feb 09, 2019 12:42 pm

Hi Keith
If you look underneath and behind that wooden fillet at each end there is 5/16 nut holding it in place
John

keithj
Posts: 25
Joined: Sun Nov 25, 2018 10:29 pm
Location: Mansfield

Re: heater control panel

Post by keithj » Sat Feb 09, 2019 12:59 pm

Ah yes, if I remove the trim panel at each side I see them. Thanks.

Post Reply