Forum registration by users has been re-enabled with harder registration questions. Guests should use the Register button top right but if you have difficulty answering one of the spambot countermeasure questions, Email mail @ chalkevalley.info (delete spaces).
If you would like to join the DLOC, please visit the Club's website https://www.dloc.org.uk/
Please don't post someone's email address. Some people don't want to risk it being harvested by spambots and GDPR regulations discourage it.
Always look at "ACTIVE TOPICS" which gives all posts in date & time order if you can't find a post or "Your Posts", as topics are sometimes moved.
Reg. nrs. Please add reg. nr. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.

Steering column noise

Post Reply
Akiri
Posts: 7
Joined: Sun Aug 20, 2017 3:06 pm
Location: Winchester UK

Steering column noise

Post by Akiri » Sun Jun 16, 2019 5:12 pm

My 1968 V8 250 is fitted with power steering and performs well,as it should.
However every 3-500 miles a’rubbing’ noise comes up from the steering column especially when turning on the lock. The plastic type top bush, from where the noise appears to emanate, has now been replaced three times but each time the noise returns.
Of course the bushes may be faulty but they come from a recognised source.
A sintered bronze replacement has been suggested but that seems a bit extreme.
Any ideas as to cause and remedy?
Thanks.
.

Superfly
Posts: 18
Joined: Wed Aug 08, 2018 8:02 pm
Location: Leicestershire

Re: Steering column noise

Post by Superfly » Sun Jun 16, 2019 8:46 pm

I had the same problem last year,but my column would get a tight spot too.
I had replaced both upper and lower bushes,they were a very tight fit and would eventually groan and tighten up after a few miles despite copious amounts of oil on assembly.
WD-40 and normal oil did not seem to last long,so I tried a different approach.

I removed the column again,stripped it back to just the inner and outer column, popped it into my vice and lubricated the bushes with an oil containing a PTFE additive.

I then put the end of the inner column into the chuck of my cordless drill and spun it up,albeit very slowly,just for a minute or so,as you do not want to overheat the plastic bushes ,whilst simultaneously applying the PTFE based oil to the top and bottom bushes,
The result is a silent,very smooth steering column,with no slack or play now
It's almost like the bushes need "running in", which would take some time with normal use.

Stu
1968 Daimler 250-V8 Saloon

Petelang
Posts: 217
Joined: Sat Feb 13, 2016 10:23 am
Location: Nottingham
Contact:

Re: Steering column noise

Post by Petelang » Mon Jun 17, 2019 9:29 am

I have just, finally, resolved this problem on a DS420 which has a very similar column.
It was nothing to do with the bushes, but a simple case of incorrect assembly of the lower yoke to the splined shaft. There is a machined recess in the very bottom of the column for the pinch bolt that clamps the yoke joint to the shaft. This had been ignored and the column pressed down further into the yoke joint. When withdrawn a bit so the pinch bolt could sit correctly in the groove, tension was released and it's now totally smooth and silent in operation.
It took a year to resolve this, including having the steering box off and on at a garage.
Sometimes it's just simple stuff...
Peter
Peter Langridge
Cloud Nine Classic Weddings, Nottingham.

Post Reply