Hi everyone. I am in the process of re-aligning the back axle using the panhard rod and have managed to get within
1/4 inch of being central. I cannot find what tolerance there is on dimension A in the manual.
I guess 1/4 inch should be ok - any comments?
Thanks, John
Please visit the Club's website https://www.dloc.org.uk/ to join. Visit https://www.dloc.org.uk/adhoc to DONATE towards the cost of the forum.
Please don't post someone's email address to avoid it being harvested by spambots and it's against GDPR regulations.
Always look at "ACTIVE TOPICS" to see all posts in date & time order as they are sometimes moved; or look at "Your Posts".
Please add Reg. nrs. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.
CHANGED YOUR EMAIL ADDRESS since registering?, click your username and check your address in User Control Panel, Profile, Account Settings.
If you want help to register, use "contact us" at page bottom for help.
Please don't post someone's email address to avoid it being harvested by spambots and it's against GDPR regulations.
Always look at "ACTIVE TOPICS" to see all posts in date & time order as they are sometimes moved; or look at "Your Posts".
Please add Reg. nrs. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.
CHANGED YOUR EMAIL ADDRESS since registering?, click your username and check your address in User Control Panel, Profile, Account Settings.
If you want help to register, use "contact us" at page bottom for help.
V8-250 saloon Rear Axle Alignment
Re: V8-250 saloon Rear Axle Alignment
Hi John,
when I replaced my panhard rod and bushes I endeavored to get the distance A as close to equal on both sides There is no measurement for A
Regards,
David B. Down under.
when I replaced my panhard rod and bushes I endeavored to get the distance A as close to equal on both sides There is no measurement for A
Regards,
David B. Down under.