V8-250 Saloon: Wiring Block Connectors
Posted: Wed Dec 04, 2019 4:22 pm
Hello,
At some stage, sooner rather than later, I will be looking to replace and improve the wiring block connectors located on the LH and RH wings along with the associated wires. As you can see from the photos they are not dreadful, but nor are they brilliant either.
The saloon has a 20x way block connector and a 10x way unit.
My understanding is that neither blocks are available, although Holden doing something similar (5x way connector ref 080.263) you can do the maths on that !!
Of course this is not a bundle of single straight through connectors, but in many cases 2x wires in at the top resulting in 1x wire only coming out at the bottom; hence the complexity of these units. I think the 20x way block connector deals with 14x wires in total, I cannot recall the number of wires on the smaller block.
I am interested to hear if any saloon owner has tackled this problem and if so the outcome, please.
Any information, gratefully appreciated.
Thank you.
Richard.
At some stage, sooner rather than later, I will be looking to replace and improve the wiring block connectors located on the LH and RH wings along with the associated wires. As you can see from the photos they are not dreadful, but nor are they brilliant either.
The saloon has a 20x way block connector and a 10x way unit.
My understanding is that neither blocks are available, although Holden doing something similar (5x way connector ref 080.263) you can do the maths on that !!
Of course this is not a bundle of single straight through connectors, but in many cases 2x wires in at the top resulting in 1x wire only coming out at the bottom; hence the complexity of these units. I think the 20x way block connector deals with 14x wires in total, I cannot recall the number of wires on the smaller block.
I am interested to hear if any saloon owner has tackled this problem and if so the outcome, please.
Any information, gratefully appreciated.
Thank you.
Richard.