Ok, here's the story...when I bought the DJ254 the engine was out, the gearbox separated and lots of bits in boxes or missing. I found a starter motor Lucas M418G which accords with the book. It's been rebuilt but when I come to reinstall I find that it has a 3 hole flange whereas the back plate only has two holes - does this matter? It fits Ok.
Comments, suggestions, advice.
Michael
Please visit the Club's website https://www.dloc.org.uk/ to join. Visit https://www.dloc.org.uk/adhoc to DONATE towards the cost of the forum.
Please don't post someone's email address to avoid it being harvested by spambots and it's against GDPR regulations.
Always look at "ACTIVE TOPICS" to see all posts in date & time order as they are sometimes moved; or look at "Your Posts".
Please add Reg. nrs. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.
CHANGED YOUR EMAIL ADDRESS since registering?, click your username and check your address in User Control Panel, Profile, Account Settings.
If you want help to register, use "contact us" at page bottom for help.
Please don't post someone's email address to avoid it being harvested by spambots and it's against GDPR regulations.
Always look at "ACTIVE TOPICS" to see all posts in date & time order as they are sometimes moved; or look at "Your Posts".
Please add Reg. nrs. when posting a photo or anything about a car as this will help searches. Don't add punctuation next to nr. as this negates search.
CHANGED YOUR EMAIL ADDRESS since registering?, click your username and check your address in User Control Panel, Profile, Account Settings.
If you want help to register, use "contact us" at page bottom for help.
DJ254 starter motor
-
- Posts: 258
- Joined: Wed Feb 10, 2016 9:15 pm
- Location: Victoria, Australia
Re: DJ254 starter motor
No problem, Michael, your starter’s 2-bolt fitting is fine. I had a DB18 with the same set up.
Steve
Steve
-
- Posts: 258
- Joined: Wed Feb 10, 2016 9:15 pm
- Location: Victoria, Australia
Re: DJ254 starter motor
Thanks Steve.
Regards
Michael
Regards
Michael