Please don't post someone's email address. Some people don't want to risk it being harvested by spambots and GDPR regulations discourage it.
Always look at "ACTIVE TOPICS" which gives all posts in date & time order if you can't find a post or "Your Posts", as topics are sometimes moved.
Reg. nrs. Please add reg. nr. when posting a photo or anything about a car as this will help searches. Don't add punctuation after nr. as this negates search.

Aluminium protection

Bud
Posts: 207
Joined: Fri Feb 12, 2016 9:06 pm

Re: Aluminium protection

Post by Bud » Wed Feb 13, 2019 9:06 pm

tjt77

Have any experience with powder coatings?
My intake manifold, my valve covers, pulleys, bumpers, running light surrounds, headlight and tail light surrounds, windshield frame, gas cap, door handles, hardtop rear window and port holes, and more have been powder coated for more than 15 years incurring minimal noticeable failures and I have put nearly 36k mi. on the car if that can be put forth as a reference.
The coatings are in every conceivable place on the car except under the bottom and exposed to all conditions as I do drive my car a lot.
Again most , if not all failures or flaws can just be rebaked away in most cases.
Not in the business, just very satisfied with my results.
Just start as clean and as oil free as possible for desired outcome.
Best results whatever route you take.

Christopher Storey
Posts: 228
Joined: Wed Mar 16, 2016 6:40 pm
Location: Cheshire

Re: Aluminium protection

Post by Christopher Storey » Thu Feb 14, 2019 10:51 am

Just going back to ACF 50 , it has no similarlity to WD40 at all, and forms an impermeable coating which is ideal for our wet climate in N.Europe. It really only needs to be renewed if the cast alloy is repolished . I should also say that tjt77's advice is no doubt excellent for the USA cold but dry climate zones , but does not protect in the dank European conditions where condensation is the main enemy

Ozzsp250
Posts: 153
Joined: Tue Feb 16, 2016 12:35 am
Location: Arizona, USA

Re: Aluminium protection

Post by Ozzsp250 » Thu Feb 14, 2019 4:04 pm

My experience with powder coating - some good some not.

I had my valve covers highly polished and looked great I then make the mistake of having them clear powder coated in the hope of them being easier to maintain. It turned out not so great and the powder coating place agreed and the process totally repeated [on their dime] -- second time no better, disappointing to say the least. That took place in Pittsburgh, Pennsylvania which tends to be on the humdid side. I had made that decision to polish and clear coat based on another set of valve covers on the original engine powder coated in a aluminum colour in Queensland, Australia. They were never shiny but have stayed the same over the last 10 years.

All the other parts I've had powder coated have had up very well, and are a mix of ferrous and non-ferrous metal engine components.

I was tempted to have a third set of valve covers polished and clear powder coated here in the arid Arizona desert but have yet to take that step.

Post Reply